Complete EVA/ POE polymer based , Solar Interlayer-Encapsulated Film-Sheet Extrusion Production Line , width 1123-1126 up to 1300 mm +

with Approx. 400-420,000 + Meters/Annum depending on various factors like GSM, Thickness, Width ..

Techno -Commercial Offer with …

General

This production line is suitable for the production of EVA /POE film;

1. Material EVA/POE

2. Supporting facilities requirements

Electrical supply All electrical cabinets(including main electrical

cabinets and control electrical cabinets) and internal

wires and cables of the production unit are provided

by the seller. The buyer’s responsibility is to provide

auxiliary cables and cable racks to the main electrical

cabinet/inlet power supply of the production unit

facility.

Input power voltage： 415V/3P

Maximum voltage fluctuation： ≤±15%

Frequency： 50HZ

Maximum frequency fluctuation： ±1.5HZ

Circulating cooling water supply Whether customers use an open-loop or closed-loop

circulating cooling water system, they must ensure

that the water is clean and free of sediment.

Maximum water supply temperature: 30℃

Water supply pressure: 4-6bar

Pressure fluctuation: ±0.5bar

Average return pressure: 1.5bar

Circulating water volume: 35-40m3/h

Compressed air supply Clean air source, free of oil, water and dust.

Supply air pressure: ≧7bar

Pressure fluctuation: ±1%

Air pressure: 0.9m3/h

3. Main parameters of equipment

Extruder (160/35)： Single extruder output: 300 KG

Maximum product width 1350 mm

Product thickness: 0.4-1mm (450 g/m2 @ 0.65 mm) ,thickness tolerance: ±

2.5%

Effective width of the roller： 1550 mm

The normal production speed is

7-9m/min@1300mm(depending on the customer ’ s

external conditions and raw material formulation

changes).

Chiller water requirement The rubber roller is lower than 0℃ with cooling

medium, and the embossing roller is lower than 10℃

with ordinary soft water.

II.Equipment list Quantity Remark

1. 160/35 single screw extruder(including steel

platform+ water tank)

1 unit

2. Customized plate-type screen changer 1 set

3. Melting pump(with water cooling)+ drive+

control+ temperature control device

1 set

4. Flow channel 1 set

5. T-Die(JC-times)+Die lip temperature control+

temperature control equipment

1 unit

6. Casting calendar 1 unit

7. Thickness gauge 1 unit

8. Roller temperature controller 1 set

9. Cooling bracket 1 set

10. Edge trimming and slitting device 1 set

11. Static eliminator 1 unit

12. Haul-off 1 set

13. Friction centre winder(automatic cutting and

manual winding)

1 unit

14. Full set of electrical control system 1 set

15. Side trimmed edge extruder 1 set

16. Conical mixer (Manually feed each component) 1 set